Inicio > Conocimiento > Contenido

Nov 18, 2022



Droplet - air touch

The central component of the spray dryer is the spray drying chamber. In a chamber, the atomized liquid is brought into contact with a hot gas (usually air under a vacuum), causing more than 95% of the water droplets to evaporate within a few seconds. The way the spray comes into contact with the air in the dryer affects the behavior of the droplets during the drying phase and directly affects the properties of the dried product. The type of contact between spray and air is determined by the position of the atomizer relative to the air inlet. The nozzle head is usually located at the top of the dryer and sprays downward.

Water transpiration occurs in two stages. During the preliminary phase, the temperature in the saturated air at the droplet's surface is approximately equal to the wet-bulb temperature of the dry air. There is enough water in the droplets to replace the liquid evaporating on the surface, and the evaporation occurs at a relatively stable rate. At the beginning of the second stage, there is no longer enough moisture to maintain a saturated state on the surface of the droplet, resulting in the formation of a dry shell on the surface. Transpiration then depends on the diffusion of water through the shell, which increases in thickness. In the second stage, the transpiration rate decreases rapidly. Different products have different transpiration and particle composition characteristics. Some swell, some shrink, crack or disintegrate.

Envíeconsulta
Categoría de producto